Created carefully, each tile itself is a work of art. No two tiles are absolutely identical and their variations enhance their beauty. A single sample can therefore not be taken as an accurate representation. Some of these handcrafted tiles may also have minor chips, pinholes and blemishes. These imperfections are the characteristics of the product.
 
 

We advise you to consult with your sales executive to ensure that the tile you choose is suitable for the application you have in mind.
 
 

Any of our Stone Products and Clay Pavers can be used for "heavy traffic areas" such as commercial, official and public places.

..

What is Roman Mosaic? Is it suitable for all areas?
..

In roman Mosaic, the stone or the ceramic tile is cut to size into tessare and assembled on mesh as per the design.

Roman Mosaic can be set on walls and floors. However, it is not recommended for wet areas due to the extra maintenance required.

Ceramic Roman Mosaic is not recommended for high traffic areas.
..

Sealers are recommended for use on most unglazed surfaces such as the Clay Pavers, Stone Roman Mosaic, Dimensional Stone and Antique Stone to protect the stone from any kind of staining and also to enhance its natural colour.

Under normal conditions, sealants will usually last three to four years and for maintenance, follow the manufacture's instructions.

Roval 1088 is recommended for all Antique Stones, Dimensional Stone and Stone Mosaic Borders and Motifs. Roval 1088 gives a "wet look" to the surface.

Hydro Block can also be used if a natural look is required. It can also be used as a grout sealer. Reflecta Polish is recommended if a high gloss look is required.
  

Due do their handmade character, their installation requires a little more care than the regular machine-made tiles. All our mosaics are pre-assembled on fibre mesh and are ready-to-lay.

The two most common installation methods are "thick-bed" and "thin-set". The choice of method depends on the structure and condition of the surface to be tiles as well as its intended use.

The "thick-bed" technique involves applying tiles over a bed of portland cement mortar up to 2 inches thick. In the "thin-set" method, the tiles are set or bonded directly to the existing surface with a thin coat of adhesive up to an eighth of an inch in thickness. In general, if the surface to be tiled is in poor condition a thick-bed method is best. Where the existing surface is rigid, round and smooth, a thin-set method may work better.

‘Grout’ is applied to the joints after the tile has set, depending on the mortar used; this may take anywhere from three hours to two days after installation. ‘Grout’ is mixed to the proper consistency and then applied with a rubber float or squeegee to an area of approximately 20 square feet at a time. Rubbing firmly over the tiled surface pushes the grout into the joints and cleanses most of the excess. The excess grout is then wiped clean.

..

The cleaning solution used should always be rinsed removed from the surface with water. Soap should not be used to clean ceramic tiles as it forms a film dulling the luster and promotes the growth of mildew and bacteria in damp areas such as showers. In particular, avoid using acid-based detergents that are harsh and corrosive. Acid should NEVER be used to clean the tiles.

Dirt in the from of powder and sand, aggravate the abrasion caused by traffic; their presence and direct access to the premises from outside are factors that shorten the life of the tiles.

You should therefore keep the floor as clean as possible in order to get around this.

..